The effect of speed on cutting quality

1

1. The effect of too fast speed on cutting quality:

* It may cause inability to cut and sparks splashing;

* Some areas can be cut off, but some areas cannot be cut off;

* Cause the entire cutting section to be thicker, but there are melting stains;

* The speed is too fast, causing the sheet to be unable to be cut in time, the cutting section shows an oblique streak road, and melting stains are produced in the lower half.

 

2. The effect of too slow speed on cutting quality:

* It causes over-melting of the cut sheet, and the cut section is rough;

* The cutting seam will widen accordingly, causing the whole area to melt in the round or sharp part, and the ideal cutting effect will not be obtained;

*  Low cutting efficiency affects productivity.

1

 

The cutting speed can be judged from the cutting spark, and the appropriate cutting speed can be selected:

* When the cutting speed is appropriate: the cutting sparks spread from top to bottom;

* When the cutting speed is too fast: the cutting spark is inclined;

*When the cutting speed is too slow: cutting sparks appear non-spread and less, condensed.

1 2

High configuration for exchange table with cover.

https://www.cheeronlaser-mfg.com/front-of-electric-cabinet-product/


Post time: Jan-28-2021